Перевод: с английского на все языки

со всех языков на английский

reactive load factor

См. также в других словарях:

  • Load bank — A load bank is a device which develops an electrical load, applies the load to an electrical power source and converts or dissipates the resultant power output of the source. The purpose of a load bank is to accurately mimic the operational or… …   Wikipedia

  • Volt-amperes reactive — In alternating current power transmission and distribution, volt ampere reactive power (VAr) is a unit used to measure reactive power in an AC electric power system. 1 VAr = 1 V·A. [http://www.iec.ch/zone/si/si elecmag.htm SI units – Electricity… …   Wikipedia

  • Demand factor — In telecommunication, electronics and the electrical power industry, the term demand factor has the following meanings: 1. The ratio of (a) the maximum real power consumed by a system to (b) the maximum real power that would be consumed if the… …   Wikipedia

  • Power factor — For other uses, see Power factor (pistol). The power factor of an AC electric power system is defined as the ratio of the real power flowing to the load over the apparent power in the circuit,[1][2] and is a dimensionless number between 0 and 1… …   Wikipedia

  • коэффициент реактивной нагрузки — — [Я.Н.Лугинский, М.С.Фези Жилинская, Ю.С.Кабиров. Англо русский словарь по электротехнике и электроэнергетике, Москва, 1999 г.] Тематики электротехника, основные понятия EN reactive load factorRLF …   Справочник технического переводчика

  • Electric power transmission — Electric transmission redirects here. For vehicle transmissions, see diesel electric transmission. 400 kV high tension transmission lines near Madrid Electric power transmission or high voltage electric transmission is the bulk transfer of… …   Wikipedia

  • Maximum power transfer theorem — In electrical engineering, the maximum power transfer theorem states that, to obtain maximum external power from a source with a finite internal resistance, the resistance of the load must be equal to the resistance of the source as viewed from… …   Wikipedia

  • Maximum power theorem — In electrical engineering, the maximum power (transfer) theorem states that, to obtain maximum external power from a source with a finite internal resistance, the resistance of the load must be made the same as that of the source. It is claimed… …   Wikipedia

  • Impedance matching — In electronics, impedance matching is the practice of designing the input impedance of an electrical load (or the output impedance of its corresponding signal source) to maximize the power transfer and/or minimize reflections from the load.… …   Wikipedia

  • Transformer design — This page deals primarily with the design of electrical transformers. For the definition, function, and history, see Transformer.In electrical engineering, practical transformer design requires knowledge of electrical principles, materials, and… …   Wikipedia

  • Tube sound — (or valve sound) is the characteristic sound associated with a vacuum tube based audio amplifiers. Some audiophiles prefer the sound that is produced by the distortion characteristics of tube based amplifiers. The audible significance of tube… …   Wikipedia

Поделиться ссылкой на выделенное

Прямая ссылка:
Нажмите правой клавишей мыши и выберите «Копировать ссылку»